TABLE OF CONTENTS
VHF Machines Troubleshooting Portal
https://www.dentalportal.info/en/Global_Troubleshooting/GLB_DEN_Troubleshooting.htm
VHF Tool Slot Assignment
VHF machines tool slots are changed on the controller side, not the CAM / MillBox. MillBox always refer to the same tool number in the tools archive and the controller will parse out where it's been assigned in DentalCNC for milling.
This only applies to VHF and IMES machines. The other machines utilizes the tool slot assignments in MillBox.
Was this article helpful?
That’s Great!
Thank you for your feedback
Sorry! We couldn't be helpful
Thank you for your feedback
Feedback sent
We appreciate your effort and will try to fix the article